REAR BUMPER > REMOVAL |
| 1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT |
| 2. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Using a clip remover, remove the 3 clips.
Disengage the 4 claws to remove the rear floor finish plate.
| 3. REMOVE LUGGAGE COMPARTMENT TRIM BOX |
| 4. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH |
![]() |
Using a clip remover, remove the 5 clips and the luggage compartment inner trim cover LH.
| 5. REMOVE REAR BUMPER COVER |
![]() |
Disconnect the rear light assembly connector.
Disengage the clamp and disconnect the wire harness.
![]() |
Disengage the grommet and pull out the wire harness.
![]() |
Remove the 2 screws.
![]() |
Put protective tape around the rear bumper cover.
| *1 | Protective Tape |
![]() |
Using a clip remover, remove the 6 clips.
![]() |
Remove the clip.
![]() |
Disengage the 5 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the rear bumper cover.