Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > REMOVAL

for Preparation Click here



1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


2. REMOVE REAR FLOOR FINISH PLATE


    B312237
  1. Using a clip remover, remove the 3 clips.

  1. Disengage the 4 claws to remove the rear floor finish plate.



3. REMOVE LUGGAGE COMPARTMENT TRIM BOX


B457914


4. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH


    B312226
  1. Using a clip remover, remove the 5 clips and the luggage compartment inner trim cover LH.



5. REMOVE REAR BUMPER COVER


    B313034
  1. Disconnect the rear light assembly connector.

  1. Disengage the clamp and disconnect the wire harness.



    B313035
  1. Disengage the grommet and pull out the wire harness.



    B313036
  1. Remove the 2 screws.



    B313037E01
  1. Put protective tape around the rear bumper cover.
    Text in Illustration 
    *1
    Protective Tape



    B313038
  1. Using a clip remover, remove the 6 clips.



    B313039
  1. Remove the clip.

    HINT:
    Use the same procedure for the RH and LH sides.



    B330228
  1. Disengage the 8 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH and LH sides.



    B313041
  1. Disengage the 3 guides and remove the rear bumper cover.