Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR

WASHER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL LH


2. REMOVE FRONT FENDER LINER LH


B310889
  1. Remove the bolt.

  1. Remove the grommet.

    HINT:
    The grommet need to be replaced with new ones because they will break when they are removed.



    B310890
  1. Using a clip remover, disengage the 18 clips and remove the front fender liner LH.



3. DRAIN WINDSHIELD WASHER FLUID


    B310891
  1. Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the windshield washer fluid.

    HINT:
    Use a container to collect the windshield washer fluid.



4. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    B310892
  1. Disconnect the connector.

  1. Remove the windshield washer motor and pump assembly.