Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY (for RHD)

FUEL LID LOCK CONTROL CABLE ASSEMBLY (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
  1. Engage the 7 clamps and install the fuel lid lock control cable sub-assembly.



    B310924E01
  1. Check that the matchmark of the fuel lid lock control cable sub-assembly is aligned with the center of the clamp.
    Text in Illustration 
    *a
    Matchmark



    B310925E01
  1. Install the fuel lid lock control cable sub-assembly as indicated by the arrows in the order shown in the illustration.



2. INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
  1. Connect the fuel lid lock control cable sub-assembly.

  1. Install the 2 nuts and fuel lid lock open lever sub-assembly.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Return the floor mat.



3. INSTALL HANDLE COVER
  1. Install the handle cover with the screw.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }



4. INSTALL NO. 2 PACKAGE TRAY TRIM SPACER
  1. Install the No. 2 package tray trim spacer.

  1. Install the 3 clips.



5. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

HINT:
Use the same procedure as for the LH side .



6. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER RH
  1. Install the 5 clips and the luggage compartment inner trim cover RH.



7. INSTALL REAR FLOOR FINISH PLATE
  1. Engage the 4 claws to install the rear floor finish plate.

  1. Install the 3 clips.



8. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


9. INSTALL SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



10. INSTALL FRONT SEAT ASSEMBLY
(Click here)


11. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Use the same procedure as for the LH side .



12. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side .