Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The following procedure is for the LH side.



1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING


    B313068
  1. Disengage the 2 clips and remove the center roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. If the clips are damaged or dropped off, replace them with new clips.