Home › Vehicle Exterior › MIRROR (EXT) › OUTER MIRROR SWITCH

OUTER MIRROR SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicle.
  2. The procedure listed below is for the LHD vehicle.



1. REMOVE DOOR ARMREST COVER LH


    B313118E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 7 claws.

  1. Disengage the guides and remove the door armrest cover.
    Text in Illustration 
    *1
    Protective Tape



2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B313119E01
  1. Using a screwdriver with its tip wrapped in protective tape, open the cap.
    Text in Illustration 
    *1
    Protective Tape



    B313120
  1. Using a clip remover, disengage the clip.

  1. Remove the 3 screws.



    B313121
  1. Using a moulding remover, disengage the 10 clips.

  1. Pull out the front door trim board sub-assembly in the direction indicated by the arrow in the illustration.

  1. Disconnect each connector.

  1. Raise the front door trim board sub-assembly and remove the front door trim board sub-assembly together with the front door glass weatherstrip inner.



    B313122E01
  1. Disconnect the front door lock remote control cable and the front door inside locking cable.
    Text in Illustration 
    *1
    Front Door Inside Locking Cable
    *2
    Front Door Lock Remote Control Cable



3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    B314154
  1. Remove the 4 screws and power window regulator master switch assembly with the front door armrest base panel.



4. REMOVE OUTER MIRROR SWITCH ASSEMBLY


    B314855E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the outer mirror switch assembly.
    Text in Illustration 
    *1
    Protective Tape