Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › LUGGAGE COMPARTMENT DOOR GARNISH

LUGGAGE COMPARTMENT DOOR GARNISH > INSTALLATION

for Preparation Click here



1. INSTALL RADIATOR GRILLE EMBLEM (for Rear Side)
  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      Heating Temperature:
      Item
      Temperature
      Luggage Compartment Door Panel
      40 to 60°C (104 to 140°F)

      CAUTION:
      Do not burn yourself with the hot luggage compartment door panel or with the infrared light.

      NOTICE:
      Do not heat the luggage compartment door panel excessively.

    2. Using a piece of cloth, rub the remaining double-sided tape off the luggage compartment door panel while it is hot from the infrared light.

      NOTICE:
      Installing the radiator grille emblem while any double-sided tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. Using an infrared light, heat the radiator grille emblem installation surface of the luggage compartment door panel and new radiator grille emblem.

    Heating Temperature:
    Item
    Temperature
    Luggage Compartment Door Panel
    40 to 60°C (104 to 140°F)
    Radiator Grille Emblem
    20 to 30°C (68 to 86°F)

    CAUTION:
    Do not burn yourself with the hot luggage compartment door panel and radiator grille emblem or with the infrared light.

    NOTICE:
    Do not heat the luggage compartment door panel and radiator grille emblem excessively.



    B313063E01
  1. Insert the 2 pins into the luggage compartment door panel and install a new radiator grille emblem.
    Text in Illustration 
    *1
    Location Pin



2. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
  1. Engage the 2 claws and install the back door opener switch assembly.



3. INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
  1. Engage the clip to install the 3 screws and the luggage compartment door outside garnish sub-assembly.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }

  1. Connect the 2 license plate light connectors.

  1. Connect the back door opener switch assembly connector.



4. INSTALL LUGGAGE COMPARTMENT DOOR LOCK CYLINDER PACKING (w/ Lock Cylinder)
  1. Install the new luggage compartment door lock cylinder packing.

    NOTICE:
    Do not reuse the removed packing. Be sure to install a new luggage compartment door lock cylinder packing to prevent water ingress.



5. INSTALL LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)
  1. Connect the luggage compartment door lock cable to the luggage compartment door lock cylinder assembly.

  1. Install the luggage compartment door lock cylinder assembly with the 2 nuts.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }



6. INSTALL LUGGAGE COMPARTMENT DOOR COVER (w/ Entry and Start System)


    B310905
  1. Install the luggage compartment door cover with the 7 clips.