Home › Engine / Hybrid System › FA20 EMISSION CONTROL › PURGE VALVE

PURGE VALVE > INSPECTION

for Preparation Click here



1. INSPECT PURGE VALVE


    A280551E01
  1. Measure the resistance according to the value in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    21 to 27 Ω



    A280552E01
  1. Check the operation of the purge valve.

    1. Install a clean hose to the purge valve.

    2. Check that air does not flow from port E to port F.

    3. Check that air flows from port E to port F.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Clean Hose
      V100135
      Air

      OK:
      Measurement Condition
      Specified Condition
      Battery does not connect
      Air does not flow from port E to port F
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Air flows from port E to port F

      If the result is not as specified, replace the purge valve.

    4. Remove the clean hose from the purge valve.