Home › Engine / Hybrid System › FA20 EMISSION CONTROL › PURGE VALVE

PURGE VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Air Conditioning System)


    A276538E01
  1. Disengage the 3 craws and remove the No. 1 engine cover sub-assembly.

    HINT:
    Disengage the 3 craws in the order shown in the illustration.



2. REMOVE PURGE VALVE


    A279732
  1. Remove the nut which holds the purge valve onto the intake manifold.

  1. Disconnect the purge valve connector.



    A279733E01
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Disconnect the No. 2 ventilation hose.
    Text in Illustration 
    *1
    air pressure sensor assembly connector
    *2
    No. 2 ventilation hose



    A279734E01
  1. Disconnect the No. 1 fuel vapor feed hose and No. 2 fuel vapor feed hose, and remove the purge valve with the joint wire harness.
    Text in Illustration 
    *1
    No. 1 fuel vapor feed hose
    *2
    No. 2 fuel vapor feed hose
    *3
    Joint wire harness
    *4
    purge valve



    A279735
  1. Remove the joint wire harness from the purge valve assembly.