Home › Engine / Hybrid System › FA20 EMISSION CONTROL › PURGE VALVE

PURGE VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
for Resin Intake Manifold:



2. REMOVE PURGE VALVE


    A391625E01
  1. Remove the nut which holds the purge valve onto the intake manifold.
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold

  1. Disconnect the purge valve connector.



  1. for Resin Intake Manifold



      A279733E01
    1. Disconnect the manifold absolute pressure sensor connector.
      Text in Illustration 
      *1
      air pressure sensor assembly connector
      *2
      No. 2 ventilation hose

    2. Disconnect the No. 2 ventilation hose.



    A391626E02
  1. Disconnect the No. 1 fuel vapor feed hose and No. 2 fuel vapor feed hose, and remove the purge valve with the joint wire harness.
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold
    *1
    No. 1 fuel vapor feed hose
    *2
    No. 2 fuel vapor feed hose



    A392837E01
  1. Remove the joint wire harness from the purge valve assembly.
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold