Home › Suspension › REAR SUSPENSION › REAR LOWER ARM

REAR LOWER ARM > REMOVAL

for Preparation Click here


HINT:
  1. The procedure listed below is for the LH side.
  2. Use the same procedure for the RH and LH sides.



1. REMOVE REAR WHEEL


2. REMOVE NO. 1 PARKING BRAKE CABLE SUPPORT BRACKET


    C262300
  1. Remove the bolt and No.1 parking brake cable support bracket.



3. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    C256608
  1. Remove the 2 bolts, 2 nuts and the rear No. 1 suspension arm assembly LH.



4. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)


    C257516
  1. Remove the nut and separate the rear height control sensor sub-assembly LH from the rear No. 2 suspension arm assembly LH.



5. SEPARATE STABILIZER LINK SUB-ASSEMBLY (for LH Side)


    C256612
  1. Remove the bolt, nut and separate the rear stabilizer link sub-assembly from the rear No. 2 suspension arm assembly LH.



6. SEPARATE REAR SHOCK ABSORBER WITH COIL SPRING


    C256605
  1. Remove the bolt, nut and separate the rear shock absorber with coil spring from the rear No. 2 suspension arm assembly.



7. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    C256610
  1. Remove the nut and bolt on the axle carrier side, and then separate the rear No. 2 suspension arm assembly LH.



    C256611
  1. Remove the bolt and nut on the rear suspension member side, and then remove the rear No. 2 suspension arm assembly LH.