Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEELS


2. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)


    C257516
  1. Remove the nut and separate the rear height control sensor sub-assembly LH from the rear No. 2 suspension arm assembly LH.



3. REMOVE STABILIZER LINK SUB-ASSEMBLY (for LH Side)


    C256612
  1. Remove the bolt, nut and separate the stabilizer link sub-assembly from the rear No. 2 suspension arm assembly LH.



    C262302
  1. Using a socket hexagon 5 mm, hold the stud bolt and remove the nut and stabilizer link sub-assembly from the rear stabilizer bar.

    HINT:
    Using a socket hexagon wrench 5 mm to hold the stud.



4. REMOVE STABILIZER LINK SUB-ASSEMBLY (for RH Side)

HINT:
Use the same procedure described for the LH side.



5. REMOVE REAR STABILIZER BRACKET (for LH Side)


    C256609
  1. Remove the 2 bolts and rear stabilizer bracket.



6. REMOVE REAR STABILIZER BRACKET (for RH Side)

HINT:
Use the same procedure described for the LH side.



7. REMOVE REAR STABILIZER BAR
  1. Remove the 2 rear stabilizer bushings and the rear stabilizer bar.



8. REMOVE REAR STABILIZER BAR BUSHING (for LH Side)
  1. Remove the rear stabilizer bar bushing from the rear stabilizer bar.



9. REMOVE REAR STABILIZER BAR BUSHING (for RH Side)

HINT:
Use the same procedure described for the LH side.