Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. The procedure listed below is for the LH side.
  2. Use the same procedure for the RH and LH sides.



1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


2. REMOVE REAR FLOOR FINISH PLATE


    B312237
  1. Using a clip remover, remove the 3 clips.

  1. Disengage the 4 claws to remove the rear floor finish plate.



3. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LH


    B312226
  1. Using a clip remover, remove the 5 clips and the luggage compartment inner trim cover LH.



4. REMOVE REAR WHEEL


5. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)


    C257516
  1. Remove the nut and separate the rear height control sensor sub-assembly LH from the rear No. 2 suspension arm assembly LH.



6. SEPARATE STABILIZER LINK SUB-ASSEMBLY (for LH Side)


    C256612
  1. Remove the bolt, nut and separate the rear stabilizer link sub-assembly from the rear No. 2 suspension arm assembly LH.



7. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    C256611
  1. Loosen the nut on the rear suspension member side.

    NOTICE:
    Do not remove the nut.



    C256605
  1. Remove the bolt, nut and separate the rear shock absorber with coil spring from the rear No. 2 suspension arm assembly LH.



    C256610
  1. Remove the bolt, nut and separate the rear axle carrier sub-assembly LH from the rear No. 2 suspension arm assembly LH.



8. REMOVE REAR SHOCK ABSORBER WITH COIL SPRING


    C256606
  1. Remove the 2 nuts and rear shock absorber with coil spring.

    NOTICE:
    Hold the rear shock absorber with coil spring to prevent it from falling accidentally.