Home › Engine / Hybrid System › FA20 ENGINE CONTROL › ENGINE OIL TEMPERATURE SENSOR

ENGINE OIL TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE OIL TEMPERATURE SENSOR
  1. Install a new gasket to the engine oil temperature sensor.

  1. Using a 19 mm deep socket wrench, install the engine oil temperature sensor to the cylinder head sub-assembly.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the engine oil temperature sensor connector.



2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
  1. Install the air cleaner cap with air cleaner hose with the 3 blots.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Install the air cleaner cap with air cleaner hose with the 2 hose clamps.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. Connect the No. 2 ventilation hose.

  1. Connect the mass air flow meter connector.

  1. Engage the wire harness clamp and install the wire harness to the air cleaner cap.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL