Home › Engine / Hybrid System › FA20 ENGINE CONTROL › ENGINE OIL TEMPERATURE SENSOR

ENGINE OIL TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL



2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A283417
  1. Loosen the hose clamp and disconnect the No. 2 ventilation hose.



    A283418
  1. Disconnect the mass air flow meter connector.

  1. Disengage the clamp and separate the wire harness from the air cleaner cap.



    A283419
  1. Loosen the 2 hose clamps.



    A283420
  1. Remove the 3 bolts and the air cleaner cap with air cleaner hose.



3. REMOVE ENGINE OIL TEMPERATURE SENSOR
  1. Disconnect the engine oil temperature sensor connector.



    A276075E01
  1. Using a 19 mm deep socket wrench, remove the engine oil temperature sensor.
    Text in Illustration 
    *1
    19 mm Deep Socket Wrench