Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT

VANITY LIGHT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the RH side.



1. REMOVE VISOR ASSEMBLY


    E247240
  1. Remove the 2 screws.

  1. Disengage the visor assembly from the visor holder.



    E247241
  1. Disconnect the connector and remove the visor assembly.



2. REMOVE VANITY LIGHT LENS


    B312997E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the vanity light lens.
    Text in Illustration 
    *1
    Protective Tape



3. REMOVE VANITY LIGHT BULB
  1. Remove the vanity light bulb from the visor assembly.