Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. SEPARATE FRONT FENDER LINER


    E356547
  1. Remove the bolt.

  1. Remove the 3 clips and partially remove the front fender liner.



2. REMOVE FOG LIGHT ASSEMBLY


    A392814E01
  1. Disconnect the connector.

  1. Remove the 2 screws A.

  1. Disengage the clip B and remove the fog light assembly.