Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
  1. Connect the connector.

  1. Engage the claw to install the side turn signal light assembly.



  1. Check that the side turn signal light assembly is installed securely.

    HINT:
    B314973E01
    If the side turn signal light assembly is not installed securely, widen and adjust the claw.

    Standard:
    Area
    Specified Condition
    a
    3.0 mm (0.118 in.)

    Text in Illustration 
    *1
    Side Turn Signal Light Assembly
    *2
    Claw



2. INSTALL FRONT FENDER LINER LH
  1. Install the fender liner with the 4 clips.