Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. SEPARATE FRONT FENDER LINER LH
  1. Steer the front tire right most.



    B314970
  1. Remove the 4 clips and partially remove the front fender liner.



2. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY


    B312216E01
  1. Using a screwdriver wrapped with protective tape, disengage the claw from service hole.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Service Hole

    HINT:
    Insert screwdriver on the level.

  1. Disconnect the connector to remove the side turn signal light assembly.