Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicle.



1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR
  1. Engage the 2 claws to install the automatic light control sensor.

  1. Connect the connector.



2. INSTALL NO. 1 DEFROSTER NOZZLE GARNISH


    B316697
  1. Engage the 16 claws and 8 guides to install the No. 1 defroster nozzle garnish .