Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicle.



1. REMOVE NO. 1 DEFROSTER NOZZLE GARNISH


    B316697
  1. Disengage the 16 claws and 8 guides to remove the No. 1 defroster nozzle garnish.



2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    E246464
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the automatic light control sensor.