Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicle.
  2. The procedure listed below is for the LHD vehicle.



1. INSTALL TURN SIGNAL FLASHER ASSEMBLY
  1. Connect the connector.

  1. Engage the clamp to install the turn signal flasher assembly.



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)
  1. Connect each connector.

  1. Engage the 2 claws.

  1. Engage the 6 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the screw.



4. INSTALL INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.