Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicle.
  2. The procedure listed below is for the LHD vehicle.



1. REMOVE INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)


    E252480
  1. Remove the screw.



    E252481
  1. Disengage the 6 clips.

  1. Disengage the 2 claws and separate the No. 1 instrument panel under cover sub-assembly.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



4. REMOVE TURN SIGNAL FLASHER ASSEMBLY


    B313026
  1. Using a clip remover, disengage the clamp.

  1. Disconnect the connector to remove the turn signal flasher assembly.