Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR COMBINATION LIGHT GASKET LH


    B370948
  1. Remove the rear combination light gasket LH.

    NOTICE:
    1. Be sure to remove all the traces of the old rear combination light gasket from the rear combination light lens and body LH.
    2. Do not reuse the removed packing. Be sure to install a new rear combination light gasket to prevent water ingress.



2. REMOVE REAR TURN SIGNAL LIGHT BULB


    B312222
  1. Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.



3. REMOVE REAR SIDE MARKER LIGHT BULB (w/ Side Marker Light)


    B314900
  1. Turn the rear combination light socket and wire sub-assembly with the rear side marker light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the rear side marker light bulb from the rear combination light socket and wire sub-assembly.



4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    B312223
  1. Disengage the clamp.

  1. Disconnect the connector.



    B312224
  1. Disengage the 2 clamps to remove the rear combination light socket and wire sub-assembly.