Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE REAR COMBINATION LIGHT GASKET LH


    E356557
  1. Remove the rear combination light gasket LH.

    NOTICE:
    1. Be sure to remove all the traces of the old rear combination light gasket from the rear combination light lens and body LH.
    2. Do not reuse the removed packing. Be sure to install a new rear combination light gasket to prevent water ingress.