Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    B312224
  1. Engage the 2 clamps to install the rear combination light socket and wire sub-assembly.



    B312223
  1. Connect the connector.

  1. Engage the clamp.



2. INSTALL REAR SIDE MARKER LIGHT BULB (w/ Side Marker Light)
  1. Install the side marker light bulb to the rear combination light socket and wire sub-assembly.



    B314901
  1. Turn the rear combination light socket and wire sub-assembly with the side marker light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.



3. INSTALL REAR TURN SIGNAL LIGHT BULB
  1. Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.



    B312225
  1. Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them as a unit.



4. INSTALL REAR COMBINATION LIGHT GASKET LH


    B370948
  1. Install a new rear combination light gasket LH.

    NOTICE:

    1. B370949
      Be sure to remove all the traces of the old rear combination light gasket from the rear combination light lens and body LH.
    2. Install the rear combination light gasket LH so that it is securely seated and there is no displacement.
    3. Do not reuse the removed packing. Be sure to install a new rear combination light gasket to prevent water ingress.