Home › Vehicle Interior › INTERIOR PANELS / TRIM › UPPER INSTRUMENT PANEL

UPPER INSTRUMENT PANEL > INSTALLATION

for Preparation Click here



1. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
  1. Install the instrument panel sub-assembly with the 7 screws and 2 bolts.



2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY


    B310248
  1. Install the instrument panel passenger airbag assembly with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the passenger airbag connector.

  1. Engage the clamp.



3. INSTALL AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)


    B152661
  1. Engage the 2 claws and install the automatic light control sensor.

  1. Connect the connector.



4. INSTALL INSTRUMENT PANEL ORNAMENT
  1. Engage the 3 claws and 3 clips and install the instrument panel ornament.



5. INSTALL COMBINATION METER ASSEMBLY
  1. Connect the connector.

  1. Engage the 2 clips to install the combination meter assembly.

  1. Install the 2 screws.



6. INSTALL FRONT PILLAR GARNISH LH
  1. Remove the protective cover (w/curtain shield airbag).

  1. Make sure that the front pillar garnish clip is not damaged.

    NOTICE:
    If there is any damage, replace the front pillar garnish clip with a new one.



    B319097E01
  1. Hook the tip of the front pillar garnish clip on the front pillar garnish LH as shown in the illustration.
    Text in Illustration 
    *1
    Front Pillar Garnish Clip

  1. Turn the front pillar garnish LH in the direction of the arrow.



    B319287E01
  1. Insert the 2 guides in the direction of the arrow (1).

  1. Engage the 2 clips and the front pillar garnish clip in the direction of the arrow, and install the front pillar garnish LH.
    Text in Illustration 
    *1
    Front Pillar Garnish Clip



7. INSTALL FRONT PILLAR GARNISH RH

HINT:
Use the same procedure as for the LH side.



8. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for 6 Speakers)
  1. Engage the 3 claws to install the front No. 2 speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.



9. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
  1. Connect connector.

  1. Engage the 6 claws to install the No. 2 instrument panel speaker panel sub-assembly.



10. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY (for 6 Speakers)
  1. Engage the 3 claws to install the front No. 2 speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.



11. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

HINT:
Use the same procedure as for the LH side.



12. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



14. CHECK SRS WARNING LIGHT