Home › Vehicle Interior › INTERIOR PANELS / TRIM › UPPER INSTRUMENT PANEL

UPPER INSTRUMENT PANEL > REASSEMBLY

for Preparation Click here



1. INSTALL INSTRUMENT PANEL CUSHION


    B315254
  1. Install a new instrument panel cushion.



2. INSTALL NO. 1 DEFROSTER NOZZLE GARNISH


    B316697
  1. Engage the 16 claws and 8 guides to install the No. 1 defroster nozzle garnish .



3. INSTALL INSTRUMENT PANEL REGISTER BEZEL (for LH Side)


    B315223
  1. Engage the 3 claws to install the instrument panel register bezel.



4. INSTALL INSTRUMENT PANEL REGISTER BEZEL (for RH Side)

HINT:
Use the same procedure as for the LH side



5. INSTALL NO. 2 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY


    B315260
  1. Engage the 3 claws to install the No. 2 instrument panel register sub-assembly.



6. INSTALL NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

HINT:
Use the same procedure as for the No. 2 instrument panel register sub-assembly.



7. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY


    B315256
  1. Engage the 2 clips.

  1. Install the center instrument panel register assembly with the 2 screws.



8. INSTALL NO. 3 DEFROSTER NOZZLE GARNISH


    B315261
  1. Engage the 2 claws to install the No. 3 defroster nozzle garnish.



9. INSTALL NO. 2 DEFROSTER NOZZLE GARNISH

HINT:
Use the same procedure as for the No. 2 defroster nozzle garnish.



10. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B315259
  1. Engage the 2 claws to install the No. 2 side defroster nozzle duct.



11. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT

HINT:
Use the same procedure as for the No. 2 side defroster nozzle duct.



12. INSTALL DEFROSTER NOZZLE ASSEMBLY


    B315258
  1. Engage the 5 claws.

  1. Install the defroster nozzle assembly, No. 2 side defroster nozzle duct, and No. 1 side defroster nozzle duct as a single unit with the 3 screws.



13. INSTALL NO. 2 HEATER TO REGISTER DUCT


    B315257
  1. Engage the claw.

  1. Install the No. 2 heater to register duct with the 3 screws.



14. INSTALL NO. 1 HEATER TO REGISTER DUCT

HINT:
Use the same procedure as for the No. 2 heater to register duct.