Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT CLOCK ASSEMBLY


    B312246E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (HAZARD+) - 14 (HAZARD-)
    Hazard warning signal switch off
    10 kΩ or higher
    7 (HAZARD+) - 14 (HAZARD-)
    Hazard warning signal switch on
    Below 1 Ω

  1. Apply battery voltage to the connector and check the LED illumination condition.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → 9
    Battery negative (-) → 13
    LED illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Clock Assembly)