Home › Power Source / Network › POWER DISTRIBUTION › BATTERY CURRENT SENSOR

BATTERY CURRENT SENSOR > INSPECTION

for Preparation Click here



1. INSPECT BATTERY CURRENT SENSOR ASSEMBLY


A266305E02
  1. Check the resistance of the battery current sensor assembly.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (VIN) - 3 (GND)
      Always
      3 to 10 kΩ
      1 (VIN) - 4 (IB)
      Always
      Below 0.5 kΩ
      3 (GND) - 4 (IB)
      Always
      3 to 10 kΩ

      If the result is not as specified, replace the battery current sensor assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Battery Current Sensor Assembly)



    E247247E01
  1. Check the resistance of the battery current sensor assembly.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 (THB) - 3 (GND)
      20°C (68°F) to 30°C (86°F)
      1.5 to 2.6 kΩ

      If the result is not as specified, replace the battery current sensor assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Battery Current Sensor Assembly)
      *b
      [kΩ]
      *c
      [°C (°F)]

      HINT:
      The "Condition" indicates the temperature in the vicinity of the sensor, not of the actual sensor itself.