AIRBAG CUT-OFF SWITCH > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE INSTRUMENT SIDE PANEL |
![]() |
Using a moulding remover, disengage the claw and 4 clips.
| *1 | Moulding Remover |
Disconnect the connector and remove the instrument side panel RH.
| 4. REMOVE AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Detach the 2 claws to remove the airbag cutoff switch cylinder sub-assembly from instrument side panel.