Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB

HIGH INTENSITY DISCHARGE HEADLIGHT BULB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE HEADLIGHT COVER


    B312205
  1. Turn the headlight cover in the direction indicated by the arrow shown in the illustration, and remove it.



4. REMOVE DISCHARGE HEADLIGHT BULB


    B312196
  1. Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly socket.



    B312206E01
  1. Release the set spring as indicated by the arrow in the order shown in the illustration.

  1. Remove the discharge headlight bulb.

    NOTICE:
    Do not touch the glass part of the bulb.