Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH

AIRBAG CUT-OFF SWITCH > INSPECTION

for Preparation Click here



1. INSPECT AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY


    B311951E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Airbag Cutoff Switch Cylinder Sub-assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Off
    400 Ω
    On
    100 Ω

    If the result is not as specified, replace the airbag cutoff switch cylinder.