VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration.
| Parts to be Replaced | Necessary Operation |
| Skid control ECU (Brake actuator assembly) |
|
| Steering sensor | |
| Steering column assembly | |
| Rack and pinion power steering gear assembly | |
| Wheel alignment adjustment |
| VSC SENSOR NEUTRAL MEMORIZATION |
Perform VSC Sensor Neutral Memorization.
Turn the ignition switch off.
Check that the steering wheel is centered.
Check that the shift lever is in neutral.
Apply the parking brake by pulling up the parking brake lever.
Connect the GTS to the DLC3.
Turn the ignition switch on.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Utility / VSC Sensor Neutral Memorization.
According to the display on the GTS, perform VSC sensor neutral memorization.
Turn the ignition switch off and disconnect the GTS.