Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT FENDER GARNISH

FRONT FENDER GARNISH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The following procedure is for the LH side.



1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH


    B453763E01
  1. Apply protective tape to the front fender panel in the area around the front fender moulding sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Using an infrared light, heat the front fender panel and the front fender moulding sub-assembly.

    Heating Temperature:
    Item
    Temperature
    Front Fender Panel
    40 to 60°C (104 to 140°F)
    Front Fender Moulding Sub-assembly
    20 to 30°C (68 to 86°F)

    CAUTION:
    Do not burn yourself with the hot front fender panel and front fender moulding sub-assembly or with the infrared light.

    NOTICE:
    Do not heat the front fender panel and front fender moulding sub-assembly excessively.



    B453764E01
  1. Insert piano wire between the front fender panel and the front fender moulding sub-assembly.
    Text in Illustration 
    *1
    Piano Wire
    *2
    Wooden Block
    V100145
    No. 1 Moulding Tape

  1. Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.

  1. Pull the piano wire and scrape off the double-sided tape that holds the front fender moulding sub-assembly to the front fender panel.

    NOTICE:
    Be careful not to damage the front fender panel.



    B453765
  1. Using a moulding remover, disengage the 6 clips and remove the front fender moulding sub-assembly.

    NOTICE:
    1. If reusing the garnish, take care not to damage the front fender moulding sub-assembly.
    2. Be careful not to damage the vehicle body.