Home › Engine / Hybrid System › FA20 STARTING › IGNITION SWITCH

IGNITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    A281434E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    All combinations of all terminals
    LOCK
    10 kΩ or higher
    2 (AM2) - 3 (ACC)
    ACC
    Below 1 Ω
    2 (AM2) - 3 (ACC) - 4 (IG1)
    6 (IG2) - 7 (AM1)
    ON
    Below 1 Ω
    1 (ST1) - 2 (AM2) - 4 (IG1)
    6 (IG2) - 7 (AM1) - 8 (ST2)
    START
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Ignition or starter Switch Assembly)
    If the result is not as specified, replace the ignition or starter switch assembly.