Home › Engine / Hybrid System › FA20 STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.



2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B315188E01
  1. Using a moulding remover, disengage the 2 claws and 4 clips to remove the center instrument cluster finish panel sub-assembly.
    Text in Illustration 
    *1
    Moulding Remover



3. REMOVE METER HOOD SUB-ASSEMBLY


    B315191
  1. Remove the screw.

  1. Disengage the 12 claws, and then pull out the meter hood sub-assembly diagonally upwards to remove it.



4. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT


    B316758
  1. Remove the screw.

  1. Disengage the 6 claws and 2 clips.



    B316759
  1. Disengage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.

  1. Disconnect the connector and remove the upper instrument panel meter ornament.



5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)
(Click here)


7. REMOVE LOWER STEERING COLUMN COVER


  1. w/ Knee Airbag



      C260510
    1. Remove the 2 screws.

    2. Disengage the 4 claws and remove the lower steering column cover.



  1. w/o Knee Airbag



      C260467
    1. Remove the 2 screws.

    2. Disengage the 6 claws and remove the lower steering column cover.



8. REMOVE UPPER STEERING COLUMN COVER


    C260468
  1. Disengage the 2 claws to remove the upper steering column cover.



9. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY


    A281433
  1. Disconnect the connector.

  1. Remove the 2 screws, and remove the ignition switch.