Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY


    B299993
  1. Remove the bolt.

  1. Disengage the hook and remove the separate type rear seat cushion assembly LH.



2. REMOVE FRONT DOOR SCUFF PLATE


    B315201
  1. Disengage the 6 claws and remove the front door scuff plate LH.



3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

HINT:
Disconnect the front door opening trim weatherstrip to the extent that allows the removal of the luggage compartment trim cover.



4. REMOVE LUGGAGE COMPARTMENT TRIM COVER


    B315207
  1. Pull up the rear seatback assembly.

  1. Remove the clip.

  1. Disengage the 8 clips and remove the luggage compartment trim cover LH.



5. REMOVE QUARTER TRIM LID SUB-ASSEMBLY


    B315208
  1. Along the arrow in the illustration, disengage the 6 claws.



    B315209
  1. Disengage the 2 clips and 2 guides.

    HINT:
    Make the quarter trim lid sub-assembly LH hang down from the lid cover clip.



    B316678E01
  1. Push the lid cover clip knobs in the direction of the arrow to remove the 2 lid cover clips along with the quarter trim lid sub-assembly LH.
    Text in Illustration 
    *1
    Lid Cover Clip

  1. Remove the 2 lid cover clips from the lid cover LH.

    NOTICE:
    If there is any damage, be sure to replace the lid cover clip with a new one.



6. REMOVE REAR WINDOW SIDE GARNISH


    B315213
  1. Remove the bolt.

  1. Disengage the 2 clips and guide remove the rear window side garnish LH.



7. REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    B311340
  1. Remove the bolt and disconnect the floor anchor of the rear seat 3 point type outer belt assembly.



    B311341E01
  1. Remove the bolt A.

  1. Loosen the bolt B and remove the rear seat 3 point type outer belt assembly.