Home › Vehicle Interior › LIGHTING (INT) › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER


    E247991E01
  1. Apply battery voltage to the connector and check the light comes on.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → 2 (ILL+)
    Battery negative (-) → 6 (ILL-)
    Light comes on

    If the result is not as specified, replace the transponder key amplifier.
    Text in Illustration 
    *a
    Component without harness connected
    (Transponder Key Amplifier)