Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER

NOISE FILTER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicle.



1. INSTALL NOISE FILTER
  1. Engage the guide and install the radio setting condenser.

  1. Engage the 2 clamps.

  1. Connect the connector.



2. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    B269715
  1. Connect the connector as shown in the illustration.



    B269713E01
  1. Slide the lever as indicated by the arrow shown in the illustration.
    Text in Illustration 
    *1
    Lever



    B269711
  1. Connect the connector indicated as shown in the illustration.

  1. Install the instrument panel junction block assembly with the bolt and the nut.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect 6 connectors to the instrument panel junction block assembly.



    C260463E01
  1. Connect the 3 connectors to the power steering ECU assembly.

  1. Connect the connector to the power steering ECU assembly.

    1. As shown in the illustration, return the lock lever to its original position to connect the connector and securely push in the lock of the lock lever.
      Text in Illustration 
      *a
      Return the lock lever
      *b
      Push the lock



3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)
  1. Connect each connector.

  1. Engage the 2 claws.

  1. Engage the 6 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the screw.



4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



5. INSTALL INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.