Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER

NOISE FILTER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. REMOVE INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)


    E252480
  1. Remove the screw.



    E252481
  1. Disengage the 6 clips.

  1. Disengage the 2 claws and separate the No. 1 instrument panel under cover sub-assembly.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



4. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    C260461E01
  1. Disengage the clamp.

  1. Disconnect the connector from the power steering ECU assembly.

    1. As shown in the illustration, pull out the lock of the lock lever and turn the lock lever to disconnect the connector.
      Text in Illustration 
      *a
      Pull out the lock
      *b
      Turn the lock lever

  1. Disconnect the 3 connectors from the power steering ECU.



    E247242
  1. Disconnect the 6 front side connectors from the instrument panel junction block assembly indicated as shown in the illustration.



    E247243
  1. Remove the bolt, nut and the instrument panel junction block assembly.



    B269710
  1. Disconnect the connector indicated as shown in the illustration.



    B269712E01
  1. Disengage the claw and slide the lever upwards.
    Text in Illustration 
    *1
    Lever



    B269714
  1. Disconnect the connector indicated as shown in the illustration.

  1. Remove the instrument panel junction block assembly.



5. REMOVE NOISE FILTER
  1. Disconnect the connector.



    E252490
  1. Disengage the 2 clamps.



    E252491
  1. Disengage the guide and remove the noise filter.