Home › Vehicle Interior › METER / GAUGE / DISPLAY › TRIP SWITCH

TRIP SWITCH > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. INSTALL TRIP SWITCH
  1. Engage the 2 claws to install the trip switch.



2. INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT
  1. Connect the connector.

  1. Engage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.

  1. Engage the 2 clips and 6 claws.

  1. Install the upper instrument panel meter ornament with the screw.



3. INSTALL METER HOOD SUB-ASSEMBLY
  1. Engage the 12 claws.

  1. Install the meter hood sub-assembly with the screw.



4. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
  1. Engage the 4 clips and 2 claws to install the center instrument cluster finish panel sub-assembly.