Home › Vehicle Interior › METER / GAUGE / DISPLAY › TRIP SWITCH

TRIP SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B315188E01
  1. Using a moulding remover, disengage the 2 claws and 4 clips to remove the center instrument cluster finish panel sub-assembly.
    Text in Illustration 
    *1
    Moulding Remover



2. REMOVE METER HOOD SUB-ASSEMBLY


    B315191
  1. Remove the screw.

  1. Disengage the 12 claws, and then pull out the meter hood sub-assembly diagonally upwards to remove it.



3. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT


    B316758
  1. Remove the screw.

  1. Disengage the 6 claws and 2 clips.



    B316759
  1. Disengage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.

  1. Disconnect the connector and remove the upper instrument panel meter ornament.



4. REMOVE TRIP SWITCH


    B312952
  1. Disengage the 2 claws to remove the trip switch.