TRIP SWITCH > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel) |
![]() |
Using a moulding remover, disengage the 8 clips and 2 claws to remove the instrument panel ornament.
| *1 | Moulding Remover |
| 2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel) |
![]() |
Using a moulding remover, disengage the 2 claws and 4 clips to remove the center instrument cluster finish panel sub-assembly.
| *1 | Moulding Remover |
| 3. REMOVE METER HOOD SUB-ASSEMBLY |
![]() |
Remove the screw.
Disengage the 12 claws, and then pull out the meter hood sub-assembly diagonally upwards to remove it.
| 4. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT |
![]() |
Disengage the 6 claws and 2 clips.
![]() |
Disengage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.
Disconnect the connector and remove the upper instrument panel meter ornament.
| 5. REMOVE TRIP SWITCH |
![]() |
Disengage the 2 claws to remove the trip switch.