Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The following procedure is for the LH side.



1. REMOVE OUTER MIRROR LH


    B314846
  1. Push the outside part of the outer rear view mirror sub-assembly LH and tilt it as show in the illustration.



    B314847E01
  1. Push the upper part of the mirror surface and tilt it.

  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B314848E01
  1. Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror sub-assembly, and separate the outer mirror.
    Text in Illustration 
    *1
    Moulding Remover



  1. w/o Mirror Heater:



      B314849
    1. Disengage the 2 claws at the upper part of the outer mirror LH.

    2. Remove the outer mirror.



  1. w/ Mirror Heater:



      B314850
    1. Disengage the 2 claws at the upper part of the outer mirror LH.

    2. Disconnect the 2 connectors and remove the outer mirror LH.



2. REMOVE OUTER MIRROR COVER LH


    B375864E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B375865
  1. Using a screwdriver, disengage the 4 claws.



    B375866E01
  1. Insert a moulding remover, and then disengage the 2 claws while sliding the moulding remover slowly in the direction of the arrow to remove the outer mirror cover LH.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Moulding Remover