Home › Steering › STEERING COLUMN › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH ASSEMBLY


  1. Measure the resistance according to the value(s) in the table below.


    C361466E01


    Text in Illustration 
    *a
    Component without harness connected
    (Steering Pad Switch Assembly)
    *b
    VOL+
    *c
    VOL-
    *d
    MODE
    *e
    SEEK+
    *f
    SEEK-
    *g
    ENTER
    *h
    UP
    *i
    DOWN
    *j
    LEFT
    *k
    RIGHT
    *l
    BACK

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z9-6 (AU1) - z9-5 (AU-GND)
    No switch pushed
    98 to 102 kΩ
    VOL+ switch pushed
    Below 2.5 Ω
    VOL- switch pushed
    322 to 336 Ω
    SEEK+ switch pushed
    980 to 1020 Ω
    SEEK- switch pushed
    3048 to 3172 Ω
    z9-2 (DP) - z9-4 (EAU)
    No switch pushed
    98 to 102 kΩ
    LEFT switch pushed
    Below 2.5 Ω
    UP switch pushed
    322 to 336 Ω
    DOWN switch pushed
    980 to 1020 Ω
    RIGHT switch pushed
    3048 to 3172 Ω
    z9-1 (AU2) - z9-5 (AUGND)
    No switch pushed
    98 to 102 kΩ
    MODE switch pushed
    Below 2.5 Ω
    z9-3 (DP2) - z9-4 (EAU)
    No switch pushed
    98 to 102 kΩ
    ENTER switch pushed
    Below 2.5 Ω
    BACK switch pushed
    980 to 1020 Ω
    z9-12 (HO) - A-1 (HO)
    Always
    Below 2.5 Ω
    z9-10 (ECC) - B-1 (ECC)*
    Always
    Below 2.5 Ω
    z9-11 (ECC) - B-3 (ECC)*
    Always
    Below 2.5 Ω

    *: w/ Cruise Control System
    If the result is not as specified, replace the steering pad switch assembly.

  1. Check the illumination.

    1. Connect a positive (+) lead from the battery to the terminal z9-8 (ILL+) and a negative (-) lead to the terminal z9-9 (ILL-) of the steering pad switch assembly connector.

    2. Check that the switch illumination illuminates.

      OK:
      The steering pad switch illumination illuminates.

      If the result is not as specified, replace the steering pad switch assembly.