STEERING GEAR > DISASSEMBLY |
| 1. SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY |
![]() |
Using SST, secure the rack and pinion power steering gear assembly in a vise.
| *1 | Protective Tape |
| 2. REMOVE TIE ROD END SUB-ASSEMBLY LH |
![]() |
Put matchmarks on the tie rod end sub-assembly LH and the steering rack end sub-assembly.
| *1 | Matchmark |
Remove the tie rod end sub-assembly LH and lock nut.
| 3. REMOVE TIE ROD END SUB-ASSEMBLY RH |
| 4. REMOVE STEERING RACK BOOT CLIP |
Using pliers, remove the steering rack boot clip.
| 5. REMOVE NO. 1 STEERING RACK BOOT CLAMP |
![]() |
Using a screwdriver, remove the No. 1 steering rack boot clamp.
| 6. REMOVE NO. 1 STEERING RACK BOOT |
| 7. REMOVE STEERING RACK END SUB-ASSEMBLY |
Using SST, remove the steering rack end sub-assembly.

| *A | for LHD | - | - |
| *a | LH Side | *b | RH Side |
| *c | Turn | *d | Hold |

| *A | for RHD | - | - |
| *a | LH Side | *b | RH Side |
| *c | Turn | *d | Hold |
| 8. REMOVE STEERING RACK GUIDE |
![]() |
Using SST, remove the lock nut.
![]() |
Using SST, remove the steering rack guide spring cap.
Remove the steering rack guide and the steering rack guide spring.