Home › Engine / Hybrid System › FA20 STARTING › KEY LOCK UNIT

KEY LOCK UNIT > INSTALLATION

for Preparation Click here



1. INSTALL CONTROL UNIT RELAY ASSEMBLY
  1. Install the control unit relay with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
  1. Horizontally engage the 2 hinges of the outer glove compartment door.

    NOTICE:
    Make sure to install the glove compartment door assembly hinges horizontally.

  1. Engage the 2 stoppers to install the glove compartment door assembly.

  1. Engage the claw to install the glove compartment door damper.



3. INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag System)
  1. Connect the connector.

  1. Engage the 4 clips and claw to install the instrument side panel RH.



4. INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag System)
  1. Engage the 4 clips and claw to install the instrument side panel RH.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL