Home › Engine / Hybrid System › FA20 STARTING › ENGINE SWITCH

ENGINE SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL



2. REMOVE FRONT CONSOLE BOX COVER
  1. Move the shift lever to N.



    B316857E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B316858
    B320022E01
  1. Disengage the 6 claws and remove the front console box cover.

    HINT:
    Hold the engine switch area and the inside of the pocket with your hand, and pull off the front console box cover.

    HINT:
    Remove the instrument panel finish panel end RH, and then push the reverse side of the front console box cover with a bar (tool handle, etc.) to remove it.

    Text in Illustration 
    *1
    Bar

    NOTICE:
    Do not push the switches or the antenna with the bar (tool handle, etc.).

  1. Disconnect each connector.



3. REMOVE ENGINE SWITCH
  1. Disconnect the engine switch connector.



    A281832
  1. Disengage the 2 claws and remove the engine switch.