Home › Engine / Hybrid System › FA20 STARTING › KEY LOCK UNIT

KEY LOCK UNIT > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL



2. REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag System)


    B316757E01
  1. Using a moulding remover, disengage the claw and 4 clips.
    Text in Illustration 
    *1
    Moulding Remover

  1. Disconnect the connector and remove the instrument side panel RH.



3. REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag System)


    B310185E01
  1. Using a moulding remover, disengage the claw and 4 clips and remove the instrument side panel RH.
    Text in Illustration 
    *1
    Moulding Remover



4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B315192E01
  1. Disengage the claw and release the glove compartment door damper.
    Text in Illustration 
    *1
    Glove Compartment Door Damper



    B315193E01
  1. Release the 2 stoppers and open the glove compartment door assembly until it is horizontal.
    Text in Illustration 
    *1
    Stopper

  1. Pull the glove compartment door assembly horizontally backward to disengage the 2 hinges and remove the glove compartment door assembly.

    NOTICE:
    Be sure to pull the glove compartment door assembly horizontally to remove it.



5. REMOVE CONTROL UNIT RELAY ASSEMBLY


    A285319
  1. Disconnect the control unit relay assembly connector.

  1. Remove the bolt and control unit relay assembly unit.